Specifying Your Audio Output Settings - Matrox MXO2 Installation And User Manual

Under Miscellaneous , select First field , Second field , or Both fields
7
from the Scrub and pause menu to indicate whether you want to display
both fields or only one field when pausing video playback or scrubbing the
timeline in your project. For example, you may want to scrub the first or
second field to eliminate the flickering that can be seen in your picture when
you pause while scrubbing interlaced video.
Under Miscellaneous , select YUV or RGB from the Set HDMI output to
8
menu to set the type of video that is sent from MXO2's HDMI output. For
example, select RGB if your MXO2's HDMI output is connected to an
HDMI device that accepts an RGB signal.
9 Under Miscellaneous , click the Calibrate button to display proc amp
controls that you can use to calibrate your HDMI monitor for video (see
Chapter 5, "Calibrating Your HDMI Monitor for

Specifying your audio output settings

MXO2's simultaneous audio outputs allow you to send your audio to a variety of
devices at the same time. You can also map any audio track in your application to
any MXO2 audio output. For descriptions of the MXO2 outputs, see
on page 17.
From the Apple menu, click System Preferences , and then click the
1
Matrox MXO2
Click Audio Output .
2
Select or clear the Enable audio mapping option. If this option is cleared,
3
your application's audio track outputs will be routed to the corresponding
Defining your settings in the Matrox MXO2 preferences window
icon.
Video").
"Outputs"
31