Brita SAFF-100 User Manual page 5

STEP 2: Determine if you need to use an adapter.
If your faucet has threads on the outside:
You most likely will not need to use an adapter. Attempt to attach
the system directly to your faucet. If it does not fit, call Brita
Consumer Services at 1-800-24-BRITA (U.S.) or 1-800-387-6940
(Canada). Proceed to Step 3.
If your faucet has threads on the inside:
You will need to use one of the adapters and corresponding
washers provided. Select the proper adapter and washer that fit
onto your faucet. If neither adapter fits, please call Brita Consumer
Services at 1-800-24-BRITA (U.S.) or 1-800-387-6940 (Canada).
Place the washer into the recessed end of the adapter. Twist the
adapter (counterclockwise) onto your faucet and tighten by hand
until snug. If difficult to tighten, insert a coin into the notch in the
bottom of the adapter and twist until snug. Caution: Using pliers to
tighten the adapter may damage the threading.
NOTE:
The Brita® Faucet Filtration System cannot be attached to faucets with a
built-in spray feature at the end of the faucet.
Side View
Mounting Collar
Top View
STEP 3: Attach the
base system to your
faucet.
Position the base system so
that the filter cup is on the left
side of your faucet and the
filter replacement indicator is
facing you. Twist the mounting
collar onto the faucet and
tighten by hand until snug. Do
not tighten with pliers. Do not
over-tighten.
If you are having difficulty,
rotate the base system
backward and forward while
further tightening the
mounting collar.
3
Threads Outside – Likely No
Adapter Needed
Threads Inside – Use an Adapter