Starting The Mower; Propelling The Mower; Handle Height Adjustment - Snapper ENXT22875E Operator's Manual

Starting the Mower

The engine on this mower is equipped with a ReadyStart
system, which features a temperature-controlled automatic
choke. It does not have a manual choke or a primer.
1. Plug the starter insert (A, Figure 6) into the connection
slot in the control console.
2. Squeeze the blade control (B) against the drive
control (C).
3. Pull the drive control all the way back to the neutral
position.
NOTE: The blade control and drive control can be operated
from either side.
4. Push the start button (D) or pull the starter handle (E) to
start the engine.
5. To stop the engine (and blade), release the blade
control.
6. After the engine starts, allow a brief warm-up until the
engine runs smooth before beginning mower operation.
D
E
A
Figure 6: Starting the mower

Propelling the Mower

1. Start the engine.
2. Begin slowly pushing the drive control (A, Figure 7)
forward to propel the mower. Forward speed can be
increased by pushing the drive control further forward.
NOTE: The drive control can be operated from either side.
IMPORTANT: Upon initial use, the drive control may have
to be adjusted. Refer to the section entitled "Drive Control
Adjustment".
Stopping the Mower
1. Stop forward motion of the mower by pulling the drive
control all the way back.
2. Stop the engine and blade by releasing the blade
control.
3. Remove the starter insert from the control console.
C
B
®
Figure 7: Propelling the mower
!
To prevent unauthorized starting, always remove the
starter insert when leaving the mower unattended.

Handle Height Adjustment

!
DO NOT attempt any maintenance, adjustments or service
with engine and blade running. STOP engine and blade.
Remove starter insert. Disconnect spark plug wire and
secure away from spark plug. Engine and components
are HOT. Avoid serious burns, allow sufficient time for all
components to cool.
For greater operator comfort, the height of the mower handle
can be adjusted.
1. Turn the two locking knobs (A, Figure 8) a quarter-turn
to unlock the handle assembly (B).
2. Align the handle assembly with one of the three handle
height adjustment holes (C) in the mounting brackets.
3. Return the locking knobs to their original position to
lock the handle.
B
Figure 8: Adjusting the handle height
Operation
A
WARNING
WARNING
C
A
!
!
11