Table of Contents
Advertisement
2 Connecting to BSGX4e
The
LED on the front panel is off and then red during the start-up process. When
STATUS
the LED is steady green, the unit is ready for operation.
Connect the Internet cable.
Step 2
The Internet cable for the BSGX4e is an Ethernet cable from your DSL or cable modem.
Connection to other Internet outlets is possible, but these modems are the most common
source.
Connect the Ethernet cable to the BSGX4e
connection diagram in
After connecting the cable, the
link is active. The LED flickers when data is being passed. The LED blinks slow when no
signal is detected.
Connect your PC to the BSGX4e.
Step 3
Connect an Ethernet cable from your PC to any of the LAN ports labeled
panel. See the connection diagram in
The front panel contains green LEDs labeled
the back panel ports.
The LED corresponding to the port where you connected the PC cable is steady green
when the link is active. The LED flickers when data is being passed.
These lighting patterns apply to all equipment that you connect to the LAN ports. You
are instructed to connect your equipment to the LAN ports after the configuration
process.
Step 4
Open a Web browser (Internet Explorer or Firefox) on your computer.
In the address bar of your browser, enter:
192.168.1.1
o
The login page opens.
On the login page:
Step 5
17
Figure 1
on
page 10
LED on the front panel is steady green indicating the
WAN
Figure 2
port on the back panel. See the
WAN
for reference.
on
page 11
for reference.
Ethernet 10/100
and
Initial connections
on the back
1–4
1–4
that correspond to
NN47928-311
Advertisement
Table of Contents
