Paradyne Nortel Backbone Link Node Router 5030 Installation Instructions Manual page 7

Reconnecting to the Local Loop
Procedure
1. Feed new jumper wiring through the POTS splitter rubber grommet. Remove the
insulation at the end of the wiring.
2. On the left side labeled LINE, attach red to terminal screw P1 and green to terminal
screw P2. Tighten both terminal screws with a flat-blade screwdriver.
POTS Splitter
Red
Green
New Wiring from
Punchdown
Block or NID
LINE PHONE
P1 P2 P3 P4
7
Red
Green
To
Telephone
97-15257-01