Table of Contents
Advertisement
38 Chapter 2 Cabling the VPN Router and turning the power on
The power cord must meet the requirements described in
Table 3 Power cord requirements
Requirement
Current rating
Certification
Cord length and flexibility The power cord must be less than 4.5 meters (14.7 feet) long.
Power supply connector
Wall outlet connector
To connect the power cord and turn on the system power:
1
2
3
NN46110-318 02.01
Connect the power cord to the AC receptacle on the back of the gateway (see
Figure 7 on page
37).
Connect the power cord to the power outlet.
Caution: Risk of equipment damage
Protect the VPN Router 2750 by plugging it into a surge suppressor.
Press and release the power switch on the rear of the VPN Router 2750
(Figure 7 on page
37), and wait for the gateway to boot.
Description
The power cord must be rated for the available AC voltage
and must have a current rating that is at least 125 percent of
the gateway's current rating (5 A @ 100 VAC or 3 A @ 240
VAC).
The power cord must have certification marks from an
acceptable regional agency.
It must be a flexible HAR (harmonized) cord or VDE-certified
cordage to comply with the gateway's safety certifications.
The connector that you plug into the AC receptacle on the
gateway must be an IEC 320, Sheet C13 female.
The power cord must terminate in a male plug with
appropriate grounding.
Table
3.
Advertisement
Table of Contents
