Figure 24 Installing And Removing An Option Card - Nortel VPN Router 2750 Installation Manual

Figure 24 Installing and removing an option card

Option card
Motherboard
8 Lower the new option card into the slot, and gently press the connector into
the slot.
Seat the card firmly in the slot. If you do not properly seat the card, it does not
work.
9
Replace the screw that secures the card to the slot
10 Replace the top cover on the chassis
a
Hold the cover at an angle, and slide it onto the chassis.
b Insert the four screws that secure the cover to the chassis, and use a
screwdriver to tighten the screws.
11 Do the following to install the VPN Router 2750 in an equipment rack:
Chapter 4 Installing option cards and DIMMs 71
Rear of unit
Option card slots
(Figure 21 on page
Nortel VPN Router Installation — VPN Router 2750
Filler panel screw
CS2600017A
(Figure 24 on page
65).
71).