Table of Contents
Advertisement
Hardware Connection
LAN 1-4
Four 10/100/1000 auto-sensing Ethernet ports that can be
used for computers and other devices that have an Ethernet
(Gigabit Ethernet
1-4)
port.
Press and hold this recessed button at least 8 seconds in
RESET
the unlikely event that you want to restore the default factory
settings. This button is recessed to prevent accidental resets
of your cable modem/router.
RF
You must connect your coaxial cable line to this port.
POWER
You must connect the supplied power cube to this port.
Connecting Model 5360 wirelessly to some device
1
First locate the wireless connection setup on your wireless device, and then select a cable
modem/router network whose name starts with the SSID name on the bottom label. The SSID name
on the bottom label is for model 5360's 2.4 GHz frequency band. Model 5360's 5 GHz band has the
same name plus -5G at the end, and is only visible if your wireless device works at 5 GHz. If your
device supports both frequencies, you can pick either SSID. A major advantage of the 5 GHz band is
that it's normally much less crowded with other devices trying to use that band. This is especially
important in areas with lots of wireless devices, such as in some cities and in multi-family buildings. If
your wireless device supports both frequencies and you're not happy with your speed and/or range,
you may want to try the other frequency.
2
Next you will be prompted to enter the Security Key or Password for your wireless network. The
WPA/WPA2 security key is printed on the bottom label of your cable modem/router and is unique to
you. Please use that key.
Advertisement
Table of Contents
