Mounting Bracket; T7406 Pre-Installation Programming - Nortel T7406 Installation Manual

22 / Installing the Base Station

Mounting Bracket

Mounting
bracket

T7406 Pre-installation Programming

Before connecting the T7406 base station to your system, you must set
up system programming for the handset lines.
Have the system administrator set up this programming:
1. Program Handsfree to Auto.
2. Program a maximum of three lines to each handset.
3. Assign Ring & Appear on the lines you assign to the handset.
Note: Appear only does not allow the handset to wake from
Handset Asleep mode.
4. Set the Page zone to None.
Note: Handsets can send Page announcements, but they cannot
receive them.
5. Set DND on Busy to Yes if you do not want your calls
interrupted with a ring tone when a second call comes in. Instead,
the button flashes, indicating an incoming call.
6. Other telephone programming is the same as for the M7310
telephone, with the exception of the memory key locations.
P0606142 01
Notches match to bracket.