Mounting; Orientation; Rigging - Chauvet Beamer 8 User Manual

Mounting

Orientation

Rigging

Mounting Diagram
Page 8 of 17
Before mounting the product, read and follow the safety recommendations indicated in
the Safety Notes.
The Beamer 8 may be mounted in any position; however, make sure adequate
ventilation is provided around the product.
·
Before deciding on a location for the product, always make sure there is easy
access to the product for maintenance and programming purposes.
·
Make sure that the structure onto which you are mounting the product can support
the product's weight. See the
·
When mounting the product overhead, always use a safety cable. Mount the
product securely to a rigging point, whether an elevated platform or a truss.
·
When rigging the product onto a truss, use a mounting clamp of appropriate weight
capacity.
·
When power linking multiple products, mount the products close enough for power
linking cables to reach.
·
The bracket adjustment knobs allow for directional adjustment when aiming the
product to the desired angle. Only loosen or tighten the bracket knobs manually.
Using tools could damage the knobs.
Safety Cable
(such as CH-05 from
Chauvet)
Adjustment
· When aiming the products, you may use the bracket adjustment knob(s) on the bracket.
Loosen the knob(s), adjust to the desired angle, and then tighten the knob(s) by turning
clockwise. Do not use tools for this step, as it may cause damage.
· Each LED beam head is mounted on a multidirectional pivot, and can be manually
adjusted to most positions.
Technical Specifications
Bracket
Knob
for weight information.
Mounting Clamp
(such as the CLP-15N from
Chauvet)
Mounting
Bracket
Beamer 8 User Manual Rev. 1