Bosch AKE 30-19 S Original Instructions Manual page 31

OBJ_BUCH-1238-001.book Page 31 Friday, April 30, 2010 9:39 AM
Tensioning the Saw Chain (see figure A)
Always check the chain tension before use, after
the first cuts and regularly during use approx.
every 10 minutes. Upon initial operation, new
chains can lengthen considerably.
The chain life of the saw chain mainly depends
upon sufficient lubrication and correct tension-
ing.
Avoid tensioning the chain if it is hot, as this will
cause the chain to become overtensioned and
face too tightly against the chain bar when it
cools down.
– Place the chain saw on any suitable flat sur-
face.
– Turn locking knob 15 approx. 1 – 3 turns anti-
clockwise to loosen the chain bar.
– Check if the chain links are correctly located
in the slot around the chain bar 12 and on the
drive sprocket 18.
15 14
– Turn the red chain-tensioning ring 14 clock-
wise ratcheting until the correct chain ten-
sion is reached. The ratchet mechanism pre-
vents the chain tension from loosening. If the
chain-tensioning ring 14 is hard to turn, loos-
en the locking knob 15 further in anticlock-
wise direction. The locking knob 15 may also
turn, when adjusting the chain-tensioning
ring 14.
– The saw chain 11 is correctly tensioned when
it can be raised approx. 3 – 4 mm from the
chain bar in the centre. This should be done
by using one hand to raise the saw chain
against the weight of the machine.
Bosch Power Tools
– If the saw chain 11 is overtensioned, turn the
chain-tensioning ring 14 in anticlockwise di-
rection.
Clamping the Chain Bar
– When the chain 11 is tensioned, clamp the
chain bar 12 by turning the locking knob 15
in clockwise direction. Do not use a tool for
this.
15
Saw-chain Lubrication
(see figures A–B)
Note: The chain saw is not supplied filled with
oil. It is essential to fill with oil before use. Op-
erating the chain saw without chain oil or when
the oil level is below the minimum mark will re-
sult in damage to the chain saw.
Chain life and cutting capacity depend on opti-
mum lubrication. Therefore, the chain is auto-
matically lubricated with chain oil during opera-
tion via the oil outlet 19.
Filling the oil reservoir:
– Set chain saw on any suitable surface with
the oil filler cap 4 facing upward.
– Clean area around the oil filler cap 4 with a
cloth and unscrew the cap.
– Do not remove filter insert during filling.
– Add Bosch biodegradable chain saw oil until
reservoir is full.
– Avoid dirt or debris from entering the oil res-
ervoir. Screw on oil filler cap 4 again and
tighten.
Note: Important: To allow venting of the oil res-
ervoir, small breather channels are provided be-
tween the oil filler cap and the strainer. To pre-
vent leakage ensure chain saw is left in a
11
horizontal position (oil filler cap 4 uppermost)
when not in use.
Note: It is important to use only the recom-
3 – 4 mm
mended biodegradable oil to avoid damage to
the chain saw. Never use recycled/old oil. Use of
non approved oil will invalidate the warranty.
English | 31
F 016 L70 667 | (30.4.10)