Cradlepoint IBR600 User Manual page 47

User Manual / IBR600/IBR650
Rate: Choose the length of time in seconds for each check (Default: 10 seconds. Range: 2 – 3600 seconds).
Retry: Select the number of attempts before the GRE tunnel is considered down or up (Default: 3. Range: 1 –
255).
Failover Tunnel and Failback Tunnel: Use these settings to create two tunnels – one as the primary tunnel and
one as the backup tunnel. To configure tunnel failover/failback, complete the following steps:
1. Create two tunnels: one for primary and one for backup. Make sure both tunnels have Keep Alive enabled.
2. Choose one to be the primary tunnel. Open the editor for this tunnel and make sure Tunnel Enabled is
selected. Then go to the Keep Alive page. Under Failover Tunnel select the other tunnel you have created.
3. Open the editor for the failover tunnel. Make sure Tunnel Enabled is not selected. On the Keep Alive page,
set the Failback Tunnel to your primary tunnel.
NEMO
Network Mobility (NEMO) is an Internet
standards track protocol defined in
RFC 5177. The protocol allows session
continuity for every node in a mobile
network as the network moves.
NOTE: NEMO requires a feature license
not included with ECM Prime. Go to
SYSTEM > Administration > Feature
Licenses to enable this feature.
NEMO requires a service provider, e.g.
Verizon Wireless Private Network
with DMNR (Dynamic Mobile Network
Routing). Your NEMO service provider
will define many of the settings for your
NEMO configuration.
Once you have a NEMO service provider and a valid feature license, add networks to the Networks Routed by
NEMO section by first clicking Add. In the popup window, input:
• Network Address - This is the network address that is the destination of the route. This should be set to
the network address at the remote side of the tunnel.
• Netmask - This is the corresponding subnet mask of the network being defined (Default: 255.255.255.0).
The Network Address and Netmask, or subnet mask, together define a range of IP addresses that comprise the
local network you want associated with the NEMO settings.
Network Mobility (NEMO) Settings
Enbable: Enable NEMO.
WAN: Select the WAN(s) to use for the NEMO connection. An expression such as "Unique ID is (any)" will allow
NEMO to operate on any WAN, whereas "Type is LTE" will limit NEMO operation to the WAN(s) provided by any
connected LTE device(s).
With WAN: Register the NEMO connection simultaneous with its specified WAN connection becoming available.
If not checked, will only register the NEMO connection when needed.
Home IP Address and Home Netmask – These may be provided by your NEMO service provider. The IP address
is a placeholder, "dummy" address; any IP address can be used (1.2.3.4 is common).
©2015 Cradlepoint. All Rights Reserved.
11/5/15
| +1.855.813.3385 | cradlepoint.com
47