Cradlepoint IBR600 User Manual page 33

User Manual / IBR600/IBR650
IPv4 Settings
IP Address: This is the address used by the router for local area network communication. Changes to this
parameter may require a restart to computers on this network.
Netmask: The netmask controls how many IP addresses can be used in this network. The default value is
usually acceptable for most situations.
IPv4 Routing Mode: Each network can use a unique routing mode to connect to the Internet. The default of
NAT is desirable in most configurations.
• NAT: Network Address Translation hides private IP addresses behind the router's IP address.
• Standard: Without NAT exposes the subnet addresses which requires them to be externally routable.
• IP Passthrough: IP Passthrough passes the IP address given by the modem WAN through the router.
Hotspot, VPN, and GRE must be disabled. Any Wireless interfaces must be removed from this network in
order to enable IP Passthrough.
• Hotspot: Provide Hotspot Services on this Network, requiring Terms of Service or RADIUS/UAM
authentication before WAN access will occur on both Wireless and Wired LAN connections.
IPv6 Settings
IPv6 Address Source: The Address source has three settings. The default of Delegated is desirable in most
configurations.
• Delegated: The address is provided by a router connected to this router's WAN.
• Static: The address is provided by the router admin.
• None: No use of an IPv6 WAN address, IPv6 is disabled on the WAN.
IPv6 Address: An IPv6 Address is a unique numerical label for a computer or device using the Internet Protocol
(IP). IPv6 addresses are typically in the format composed of 8 sets of 4 hexadecimal numbers. Leading zeros
can be ignored and the longest set of continuous zeros can be replaced with ::. For example, the IPv6 address
of 0001:0000:0234:5678:0000:0000:9abc:0def can be expressed as 1:0:234:5678::9abc:def.
Interfaces
Select the network interfaces which will
be attached to this network by either
dragging desired interface or clicking left
or right arrows to move them between
Available Interfaces and Selected
Interfaces.
Access Control
UPnP Gateway: Select the UPnP
(Universal Plug and Play) option if you
want to enable the UPnP Gateway service
for computers on this network.
Admin Access: When enabled users may access these
admin pages from this network.
IPv4 DHCP
DHCP Server
• Enable DHCP Server: When the DHCP server is
enabled, users of your network will be able to
automatically connect to the Internet without
any special configuration. It is recommended
©2015 Cradlepoint. All Rights Reserved.
11/5/15
| +1.855.813.3385 | cradlepoint.com
33