Cradlepoint IBR600 User Manual page 39

User Manual / IBR600/IBR650
used for end-to-end communications (for example, for communications between a client and a server). VTI
Tunnel creates a virtual tunnel interface with a specified virtual IP address. This interface can then be added to
the zone firewall.
Initiation Mode: Always On or On Demand. Always On is used if you want the tunnel to initiate the tunnel
connection whenever the WAN becomes available. Select On Demand if you want the tunnel to initiate a
connection if and only if there is data traffic bound for the remote side of the tunnel.
Tunnel Enabled: Enabled or Disabled.
Add/Edit Tunnel – Local Gateway
IP Version: Select IPv4 or IPv6.
WAN Binding: WAN Binding is an optional parameter
used to configure the VPN tunnel to ONLY operate when
the specified WAN device(s) are available and connected.
An example use case is when there is a router with both
a primary and failover WAN device and the tunnel should
only be used when the system has failed over to the
backup connection.
Make a selection for "When," "Condition," and "Value" to
create a WAN Binding. The condition will be in the form
of these examples:
When
Port
Type
• When:
• Port – Select by the physical port on the router that you are plugging the modem into (e.g., "USB
Port 2").
• Manufacturer – Select by the modem manufacturer (e.g., "Cradlepoint Inc.").
• Model – Set your rule according to the specific model of modem.
• Type – Select by type of Internet source (Ethernet, LTE, Modem, Wireless as WAN, WiMAX).
• Serial Number – Select a 3G or LTE modem by the serial number.
• MAC Address – Select a WiMAX modem by MAC Address.
• Unique ID – Select by ID. This is generated by the router and displayed when the device is connected
to the router.
• Condition: Select "is," "is not," "starts with," "contains," or "ends with" to create your condition's
statement.
• Value: If the correct values are available, select from the dropdown list. You may need to manually input
the value.
Invert Binding: Advanced option that inverts the meaning of WAN Binding to only establish this tunnel when
the specified WAN Binding device(s) are NOT connected.
Add/Edit Tunnel – Local Networks
IP Version: Select IPv4 or IPv6.
The Network Address and the Netmask define what local devices have access to or can be accessed from the
VPN tunnel.
Condition
Is
Is not
©2015 Cradlepoint. All Rights Reserved.
Value
USB Port 1
WiMax
| +1.855.813.3385 | cradlepoint.com
11/5/15
39