Famastil F-POWER Instruction Manual page 18

12
Prevent unintentional starting. Ensure
the switch is in the off-position before
connecting to power source and/or
battery pack, picking up or carrying the
tool. Carrying power tools with your
finger on the switch or energising power
tools that have the switch on invites
accidents.
Remove any adjusting key or wrench
13
before turning the power tool on. A
wrench or a key left attached to a
rotating part of the power tool may
result in personal injury.
Do not overreach. Keep proper footing
14
and balance at all times. This enables
better control of the power tool in
unexpected situations.
Dress properly. Do not wear loose
15
clothing or jewellery. Keep your hair,
clothing and gloves away from moving
parts. Loose clothes, jewellery or long
hair can be caught in moving parts.
16
Use clamps or a vice to hold your work.
It is safer than using your hand and it
frees both hands to operate the tool.
POWER TOOL USE AND CARE
17 Do not force the power tool. Use the
correct power tool for your application.
The correct power tool will dothe job
better and safer at the rate for which it
was designed.
Do not use the power tool if the switch
18
does not turn it on and off. Any power
tool that cannot be controlled with
the switch is dangerous and must be
repaired.
Disconnect the plug from the power
19
source and/or the battery pack from
the power tool before making any
adjustments, changing accessories, or
storing power tools. Such preventive
safety measures reduce the risk of
starting the power tool accidentally.
18
20 Store idle power tools out of the reach
of children and do not allow persons
unfamiliar with the power tool or these
instructions to operate the power tool.
Power tools are dangerous in the hands
of untrained users.
Maintain power tools. Check for
21
misalignment or binding of moving
parts, breakage of parts and any other
condition that may affect the power
tools operation. If damaged, have
the power tool repaired before use.
Many accidents are caused by poorly
maintained power tools.
Use the power tool, accessories and
22
tool bits etc., in accordance with these
instructions, taking into account the
working conditions and the work to be
performed. Use of the power tool for
operations different from those intended
could result in a hazardous situation.
SERVICE
23 Have your power tool serviced by
a qualified repair person using only
original replacement parts. This will
ensure that the safety of the power tool
is maintained.
ELECTRICAL SAFETY
24 Your tool is double insulated; therefore
no earth wire is required. Always check
that the main voltage corresponds to the
voltage on the rating plate.
WARNING!
If the power cord is damaged, it must
be replaced by the manufacturer,
authorized Famastil F-POWER Technical
Assistance Service or an equally
qualified person in order to avoid
damage or injury. If the power cord
is replaced by an equally qualified
person, but not authorized by Famastil
F-POWER, the warranty will not be valid.