DeDietrich DHD1122G Manual To Installation page 10

To cancel the delayed stop, press the same button and
the delay function will be deactivated.
2.1.3 - LIGHT
Press the button briefly to switch the hood's ha-
logen light on or off.
Pressing and holding the
intensity.
2.1.4 - EOLYSE FUNCTION
A short press of the
silently at a reduced speed for one hour. The
is lit and the indicator flashes.
At the end of this time, the hood stops on its own. To
stop the function, press
Programming the Eolyse function
A long press on the
The button flashes alternately with the
indicating the start of programming.
Each short press on the
eolysis time by one hour (from 1 hour to a maximum of
9 hours) and after 9, this display goes back to 1. The
hood will run silently at a reduced speed for the
selected time. The
the button (the number of successive flashes is
the number of hours selected).
Programming is confirmed automatically after 25 se-
conds or by a short press on
flashes alternately with the
Programming is confirmed by pressing the
press it a second time to cancel.
2.1.5 - EVACUATION / RECYCLE MODE
A long press (more than 2 sec) on the
tons allows you to select Evacuation or Recycle mode.
The and buttons are lit and the
ton flashes. A short press on
(the button flashes and the
A short press on selects evacuation mode (the
button flashes and the
A short press on confirms the configuration (or au-
tomatic set after 10 sec).
The hood's default mode is evacuation.
button will change the
button starts the hood running
once more.
button activates programming.
button,
button increases the
button flashes alternately with
. (The
button).
button;
and
or
selects recycle mode
button is off.
button is off.
2.1.6 - FILTER CARTRIDGE SATURATED
The button flashes (1 short flash) for 2 minutes after
the hood stops to signal that the cartridge filters must
be cleaned (see section "Cleaning the cartridge filter").
Give a long press (more than 2 sec) on
the "saturation" function.
The button flashes ( 2 short flashes) for 2 minutes
after the hood stops, to signal that the charcoal filters
must be cleaned (see section "Changing the charcoal
filter").
button
Give a long press (more than 2 sec) on
the "saturation" function.
FAN AUTO STOP
If you forget to turn the hood off, it will turn itself off au-
tomatically after 9 hours.
LIGHT AUTO STOP
If you forget to turn off the light on your hood, it will turn
itself off automatically after 9 hours.
3
button
Always unplug the hood before cleaning it or
performing other maintenance acts. Regular mainte-
nance of your appliance is a guarantee of proper
functioning, good performance and durability.
Failure to respect the guidelines for cleaning the appli-
ance and filters may cause fires. Please care fully adhere
but-
to the maintenance recommendations.
3.1
CLEANING THE FILTER CARTRIDGES
They must be cleaned after approximately 30 hours of
but-
use or at least once a month. Use a brush, hot water
and mild detergent. Rinse and dry them thoroughly
before returning them to the hood.
•Dismantling the filter cartridge
— Turn the built-in filter cartridge handle.
— Tilt the filter cartridge downward.
23
Caring for &
cleaning
EN
to unlock
to unlock