Table of Contents
Advertisement
Available languages
Available languages
This Groomer has no other user-serviceable parts. Any other service should be performed by an
Authorized Norelco Service Location.
Storage
•
Be sure Groomer is turned OFF. Remove cord from outlet and Groomer before storing in a
safe, dry location where it will not be crushed, banged, or subject to damage.
•
Store the Groomer and attachments in the storage stand to prevent damage.
•
Do not wrap cord around Groomer or stand when storing.
•
Store cord in a safe location where it will not be cut or damaged.
•
Do not place or store Groomer where it can fall or be pulled into a tub or sink, water or other
liquid while plugged in.
Replacing Trimmer Cutting Unit
If your cutters become damaged or worn, do not continue using the Groomer, Cutters should be
replaced immediately by an Authorized Norelco Service Location.
Replacing The Micro Shaver foil
If the shaving foil is worn or damaged, do not continue using the appliance. Replace the shaving
foil immediately.
A worn or damaged shaving foil should only be replaced with an original Philips shaving foil,
which is available at an authorized Norelco Service Location.
1)
Remove the detachable shaving head by pulling it from the appliance (fig. 26).
2)
Remove the shaving foil by pushing it out of the shaving head (fig. 27).
3)
Place the new shaving foil carefully in the shaving head (fig. 28).
4)
When the shaving foil is properly positioned, push it into its end position with your
finger(fig.29).
Replacing The Micro Shaver Cutter
If the micro shaver cutter is worn or damaged, do not continue using the appliance. Replace the
micro foil cutter and the shaving foil immediately. A worn or damaged micro shaver cutter should
only be replaced with an original cutter.
1)
Remove the detachable shaving head by
pulling it from the appliance (fig.26).
2)
Remove the old micro shaver cutter by pul-
ling it from the appliance (fig. 30).
3)
Make sure that the spring within the driving
unit does not get lost.
4)
Insert the new micro shaver cutter carefully
into the driving unit(fig. 31).
5)
When the micro shaver cutter is properly
positioned, push it into its end position with your finger.
6)
Replace the detachable shaving head on the appliance.
ENG - 43
ENG
Advertisement
Table of Contents
