Hyundai HC 417 Instruction Manual page 38

TRIMMING
• Make sure hair is clean and dry.
• Always comb the hair with the styling comb in the direction of growth before you start
trimming.
• Do not move the Groomer too fast. Make smooth and gentle movements.
TRIMMING yOUR BEARD & MOUSTAChE WITh CONTROL GUIDE COMB ATTAChMENT
Make sure that the Groomer is fully charged before you start trimming.
1) Put the Control comb on the full width trimmer attachment until you hear it click into place
(fig.4).The Control comb will not work with the smaller neckline and sideburn trimmer, or
micro shaver attachments.
2) Press the Hair Length Selector and slide it to the desired trimming length setting. The
selected setting number will appear in the window to the left of the Hair Length Selector
(fig.5). See Table I for settings. If you are trimming for the first time, start by using the Cont-
rol comb at the maximum rtimming length setting (#9) to prevent accidentally trimming hairs
too short. As you become familiar with the settings, adjust Hair Length Selector to desired
trimming length. Selector will „click" into plsition at each setting.
3) Switch the Groomer ON.
4) To trim in the most effective way, move the Groomer against the direction of hair growth.
Make sure the surface of the Guide Comb always stays in contact with the skin (fig.6).
NOTE: Since all hairs do not grow in the same direction, you may want to try different trimming
directions(i.e.,upwards, downwards, or across). Practice is best for optimum results. If a lot of
hair has accumulated in the Guide Comb, remove the comb and blow and/ or shake the hair out
of the comb. You can also use the cleaning brush provided to remove hair from the comb area.
REMEMBER:You must reset the hair length selector back to your desired stting every time you
replace the guide comb on the appliance.
Table 1. Beard trimmer
Setting
1 Stubble
 Closely Cropped
 Short
 Medium Short
5 Medium
6 Medium Long
7 Long
8 Extra Long
9 Longest
Remaining hair length (mm)
ENG - 38


6
8
10
12
14
16
18