Table of Contents
Advertisement
Available languages
Available languages
Clipping with hair comb attachment
1)
Put the hair clipper comb on the full width trimmer attachment and push until you hearit
‚click' into place (fig. 17).
2)
Press the Hair Length Selector and slide it to the desired setting. See Table 2.
3)
The setting selected will appear in the window to the left of the Hair Length Selector (fig. 18).
When you are clipping for the first time start at the maximum clipping length setting (#9) to
familiarize yourself with the appliance and prevent accidentally trimming hairs too short. As
you become familiar with the settings, adjust the Hair Length Selector to desired trimming
length. Selector will ‚click' into position at each setting.
4)
Make sure that the flat part of the comb is always in full contact with the scalp to obtain an
even result(fig. 19-20).
5)
Move the appliance slowly over the crown from different directions to achieve an even result
(fig. 21)
6)
Always move the appliance against the direction of hair growth.
7)
Make overlapping passes over the head to ensure that all hair that should be cut has been
cut.
8)
Turn the Groomer off and remove the hair comb often to blow and/or shake out hair that has
accumulated.
REMEMBER: You must reset the hair length selector back to your desired setting every time
you replace the hair clipping comb on the appliance.
Table 2. Hair clipper
Setting
1
5
6
7
8
9
Remaining hair length (mm)
6
8
10
12
14
16
18
20
ENG - 41
ENG
Advertisement
Table of Contents
