Hyundai HC 417 Instruction Manual page 42

Multi-purpose clipper 4 in 1
Hide thumbs Also See for HC 417:
Table of Contents

Advertisement

Available languages

Available languages

CONTOURING WIThOUT ThE hAIR CLIPPING COMB ATTAChMENT
1)
Remove the hair comb by pressing and sliding the Hair Length Selector upwards (fig.22).
Be careful when you are clipping without comb attachment as when the appliance is turned
on itwill trim every hair it touches.
2)
Tilt the appliance in such a way that only one edge of the trimming attachment touches the
hair ends when you shape the contours around the ears (fig. 23).
3)
To contour the nape of the neck or hairline, turn the appliance and hold it with the trimming
attachment pointing downwards (fig. 24).
4)
To contour the sideburns, turn the appliance and hold it with the trimming attachment poin-
ting downwards (fig. 25).
CLEANING
Do not use water or a moist cloth to clean the Groomer.
Always switch Groomer OFF before cleaning.
Do not use abrasive, scourers or liquids such as alcohol, benzene, bleach or acetone to clean
the Groomer.
Never clean, replace or remove Groomer attachments with motor ON.
Do not apply pressure to cutters .
Do not touch cutters with hard objects as this may damage them.
Do not use while bathing, showering or immerse the Groomer in water or other liquids as
damage to Groomer may occur.
During Use:
If cut hairs have accumulated in the Guide comb area, remove hairs by shaking, blowing or
using cleaning brush provided Remember to adjust the trimming length back to your selected
setting when you replace the guide comb on Groomer.
Cleaning once a week:
1)
Make sure the Groomer is switched OFF and disconnected from the electrical outlet.
2)
Remove any attachment
3)
Also separate the top part of the micro shaver attachment from its body (fig.26).
4)
Blow and/or shake out any hair that may have accumulated in the attachment.
• The shaving foil is very delicate and should not be handled.
• If foil becomes damaged, replace it. Do not apply pressure to shaving foil.
5)
Do not clean the foil with the brush, as this may cause damage.
6)
Place the attachment back on the Groomer or place it in the storage stand.
ENG - 42

Advertisement

Table of Contents
loading

Table of Contents