Sabre RG1128 Operator's Manual page 78

ENG 32
resolved the system automatically resets after a few seconds;
– a 7.5 A delayed fuse (1) for the protection of the general and power circuits of
the system. This must be replaced after having eliminated the fault.
When any of these devices are activated, the machine stops.
IMPORTANT
type and ampere rating, and never one of a different rating.
If you cannot find the cause of the protection device's activation, consult your
Dealer.
C
HANGING WHEELS
Stop the machine on a flat surface and
put blocks under a load-bearing part of
the frame on the side that the wheel is to
be changed.
The wheels are held by a snap ring (1)
which can be taken off with a screwdriver.
The rear wheels are directly coupled to
the axle shafts and fastened by a key that
forms part of the wheel's hub.
Before re-fitting a wheel, smear some
grease on the axle and carefully re-fit the snap ring and washer (2).
NOTE
they are of the same diameter, and check that cutting deck is horizontal to pre-
vent an uneven cut.
C
HANGING AND REPAIRING TYRES
Tyres are of the «Tubeless» type and therefore all puncture repairs will have to
be carried out by a tyre-repair expert in accordance with the methods for this kind
of tyres.
A blown fuse must always be replaced by one of the same
Should you substitute one or both rear wheels, ensure that
MAINTENANCE
2 1