Cleaning And Storage - Sabre RG1128 Operator's Manual

HOW TO USE THE MACHINE
The circuit automatically resets after a few seconds but the cause of the fault
should be ascertained and dealt with to avoid re-activating the protection device.
IMPORTANT
– do not reverse the cables on the battery terminals;
– do not use the machine without its battery or damage may be caused to the
charging regulator;
– be careful to not cause short-circuits.
E
ND OF MOWING
When you have finished mowing, disengage the blade
and ride the machine with the cutting deck in the
highest position.
Stop the machine, engage the parking brake and turn
off the engine by turning the ignition key to «OFF».
When the engine is stopped, close the fuel cock (1).
WARNING!
!
position for 20 seconds before stopping the engine.
WARNING!
!
unattended!

5.4 CLEANING AND STORAGE

C
LEANING
After each mowing, clean the outside of the machine, empty the grass-catcher
and shake it to remove residual grass and earth.
Clean the plastic parts of the body with a damp sponge using water and deter-
gent, taking care not to wet the engine, the electrical parts or the electronic card
located under the dashboard.
IMPORTANT
body and engine!
To avoid activating the protection device:
To avoid backfire, put the accelerator in the «SLOW»
Always take out the ignition key if leaving the machine
Never use hose-nozzles or harsh detergents for cleaning the
ENG 27
1