Table of Contents
Advertisement
%!l
000
CLEAR
o-9
000
OK
o
CH/l~~C~
!-
G-COOE
TYPE
MENU/TV
SPILP
In case of error, press the
CLEAR
button
to erase the wrong setting,
then enter the correct one.
Additional settings
After pressing the
OK
button at
step 3,
Recording tape speed/
JUST REC. mode setting
Press the SP/LP button
repeatedly to display the
desired
mode.
5P: Standard Play mode
LP: Long Play mode
A
JUST REC.
mode
(On the
VCR display)
No LP: Standard Play mode
LP:
Long Play mode
AUTO: JUST REC.
mode,
Daily/Weekly recording
Press the
MENWTV button
repeatedly to display the
desired recording
mode.
Blank:
for once
M-F: for daily recording
(Monday through Friday)
WK
for weekly recording
(the same programme
every week)
Changingthe end time
Each press of the
CH~RACK (+
or-) button will change the
recording end time by units of
10 minutes.
G-CODE
TIMER RECORDING
This VCR
has a built-in G-CODE system.
Programming
timer recordings is now as
simple as entering a G-CODE programming
number
(1 to 9 digits) listed next to each
programme
in your local TV guide or
newspaper TV programme
listing.
Turn on the TV.
Set the TV to the video channel. If using
an AV-cable,
set it to AV mode.
Programming
on-screen
1
2
3
Call up the "G-CODE" screen
using the
G-CODE button.
Using the numeric (O – 9) buttons, enter the
G-CODE programming
number for the
programme
you want to record. (e.g. 489135)
I
G-CODE
NUMBER
(4a9j:3:5::;:+:;
Press the OK button.
1
If the programme
position number (PR)
displays '–-":
Enter the programme
position number the TV
station has been preset to.
That setting will be memorized and set the
next time
the same TV station is selected.
If desired, make "Additional
settings"
on the
left to
your timer recording.
o
When allthesettings
areas desired,
press the OK button.
You can programme another recording by
repeating steps 2 to 4.
-
Insert a video cassette with
erasure-prevention
tab.
Make sure the tape is longer than the total
recording time.
5
Set the timer sandby mode using the
G-CODE button.
The timer indicator (~) will light on the
VCR display.
Programming
using the VCR display
You
can programme
or confirm a G-CODE
timer recording
on the VCR display even if the
TV is turned off.
The settings are the same as when
programming
on-screen.
1
2
3
Press the G-CODE button.
m
Enter the G-CODE programming
number
-
Press the
OK
button.
If the programme
position number (PR)
displays "--":
Enter the programme
position number the TV
station has been preset to.
That setting will be memorized and set the
next time the same TV station is selected.
If desired, make "Additional
settings"
on the
left to your timer recording.
o
Press the OK button.
You can programme
another recording by
repeating steps 2 to 4.
~
Insert a video cassette with
erasure-prevention
tab.
Make sure the tape is longer than the total
recording time.
5
Set the timer standby mode using the
G-CODE button.
The timer indicator
(n) will light on the
VCR display.
G-CODE is registered
trademarks
of
Gemstar
Development
Corporation.
The G-CODE system
is manufactured
under license from Gemstar
Development
Corporation.
Newspaper or TV guide
G-CODE programming
number
Advertisement
Table of Contents
