Table of Contents
Advertisement
TIMER RECORDING
(!)/1
FF
1
REW 1
CHANNEL ( +, -)
RECd
I
ERRORMESSAGE
"NO CASSETTE"
When the RECbutton is pressed,
this message will be displayed.
Solution:
It can be ignored because this
special method requires that no
tape be loaded the VCR,
Setting tip:
In case of error, press the
REW button to erase the
wrong setting, then enter the
correct one.
To record from an external
source (AUDIO/VIOEOIN on
the rear panel use), press the
CHANNEL(-), button to
display "L1" under "PR".
TIMER RECORDING WITHOUT USING THE
REMOTE CONTROL
If the remote control batteries are dead or if it
is not available, a timer recording
programming
can be entered using the
buttons on the VCR.
Using this method you will not be able to set
the recording type, weekly or daily recording
or PDC recording.
A
If a cassette is loaded in the VCR (the
cassette indicator (m) shown on the VCR
display), press the EJECT button to eject it
before starting the procedure below. If a
cassette is loaded in the VCR when the REC
button is pressed, recording mode will start.
1
Press the O/1 button tot.rnthe
VCR
power on.
2
Call up timer programming
screen using
the REC button for about 5 seconds.
3
Set the recording as indicated below.
Examp\e:
PR
: Programme position... 02
DATE
: Date ...25 December
START
: Start time... 09:30
END
: End time... 11:00
SPEED
: Tape speed... SP
Setting method
@)
Using the CHANNEL
(- or +) button on
the VCR, enter the desired setting.
@
Press the FF button to move to the next
entry space.
Repeat steps O and@,
enter all the other
settings.
When the tape speed is entered using the
CHANNEL
(+ or -), the timer recording is
set.
m
I
----,-- --:-- -- :--
I
[RECI+TV
[CH-+/b*/4+1
To make further timer recordings, repeat step 3.
4
Confirm theprogrammingsettings,
then
press the REC button.
m
Load a cassette tape with
erasure-prevention
tab.
Make sure the tape is longer than the
total recording time.
s
Set thetimer
standby mode using the(!)/1
button to.
The timer indicator (D) will light on the
VCR display.
A
If the REC button is pressed before
programming
is completed, the timer
recording setup mode will be cancelled.
Once a programme timer recording has
been set, it cannot be confirmed or erased
using the buttons on the VCR front panel.
(Only possible using the standard method
with the remote control.)
Advertisement
Table of Contents
