Installing The Machine - Electrolux W465H Installation Manual

24

Installing the machine

To install the machine:
• Remove the transport packaging
• Remove the front panel.
• Remove the machine from the transport pallet
and locate it on the bolts. When the machine
is lifted off the pallet: Make sure that the
machine does not come down on the floor
with either of the rear corners first. The side
panel of the machine can be damaged. Al-
ways lift the ma ch ine by the chassis, never by
the door or door handle.
• Check that the machine is level and steady in
25
all four corners mounting points. Adjust the
level by using stain less or galvanized steel
washers be tween the machine and the floor.
The wash ers must be of a size to cover the
support sur face.
• Fit the washers and self­locking nuts supplied
26
with the machine and tighten well.
• To tighten the nuts we recommend to use
27
a rachet wrench, especially in the right rear
corner.
After the machine has been in use for a while,
check and re-tighten the nuts if necessary.
Installation
25
26
27
5463
5464
5951, 5952