GSE 370 Technical Reference Manual page 31

P202 Parity (Comm 1) (Selection)
Select Odd, Even or None for the transmission parity.
P203 Stop Bits (Comm 1) (Toggle)
Select 1 or 2 stop bits for communication port transmissions.
P204 Comm Handshake (Comm 1) (Selection)
Select from None, Software (Xon/Xoff), Hardware (CTS/RTS), or Both.
P210 Send (Comm 1) (Selection)
Transmission Send options:
Choice Number Selection Name
P210.00 Off
P210.01 Press
P210.02 Cont.
P210.03 Cycle
P210.04 ID
P212 Send Stability (Comm 1) (Toggle)
Enabling Send Stability will delay any transmissions until a no-motion condition exists.
P213 Transmit Selection (Comm 1) (Selection)
Select desired print output (1 - 16 or custom). The transmission will be initiated by the selected
print operation (P210) and / or the Remote Key selection (P800). See page 29 for details on
preset formats or page 31 for details on custom transmit.
P220 Baud (Comm 2) (Selection)
Set the desired baud rate for the communication port. 150 - 115K bps
P221 Data Bits (Comm 2) (Toggle)
Select 7 or 8 data bits for the transmission.
P222 Parity (Comm 2) (Selection)
Select Odd, Even or None for the transmission parity.
P223 Stop Bits (Comm 2) (Toggle)
Select 1 or 2 stop bits for communication port transmissions.
P224 Comm Handshake (Comm 2) (Selection)
Select from None and Software (Xon/Xoff).
P230 Send (Comm 2) (Selection)
Transmission Send options:
Choice Number Selection Name
P230.00 Off
P230.01 Press
P230.02 Cont.
P230.03 Cycle
P230.04 ID
P232 Send Stability (Comm 2) (Toggle)
Enabling Send Stability will delay any transmissions until a no-motion condition exists.
Description
All transmissions disabled.
Sends transmission with [PRINT] key.
Sends transmissions continuously.
Send single transmission after weight is reached and motion ceases. Must
return display value below 0.1% of F.S. to reset for next transmission.
Sends transmission with the stored ID.
Description
All transmissions disabled.
Sends transmission with [PRINT] key.
Sends transmissions continuously.
Send single transmission after weight is reached and motion ceases. Must
return display value below 0.1% of F.S. to reset for next transmission.
Sends transmission with the stored ID.
25