Page 1
Porta-Tronic Portable Scales NSTALLATION UIDE Version 2.0...
Page 3
Information in this Installation Guide is subject to change without notice due to correction or enhancement. The information described in this manual is solely the property of GSE. No part of this manual may be reproduced or transmitted in any form or by any means, electronic or mechanical, including photocopying...
Page 5
Clear or Yellow 2. Calibration If the indicator and Porta-tronic were calibrated at the factory, the scale is now ready for use. If the indicator came separately, the scale must be calibrated to the indicator. Refer to the indicator’s manual for calibration instructions.
After each corner has been checked and calibrated, make a final check of your calibration. 3. Legal for Trade When the Porta-Tronic is used in a legal-for-trade application, sealing of the scale platform is done using one of two methods.
Page 7
Should a load cell become damaged due to an overload condition, replacement load cells can be ordered from GSE Scale Systems according to the part numbers in Table 1 on page 3. 1. Unbolt the defective load cell, and then remove leveling load foot from the load cell.
Page 8
Porta-tronic Installation Guide This page is intentionally left blank...