Table of Contents
Advertisement
Cleaning and care
Changing a lamp
The halogen lamps become very hot
during operation.
They can cause burns even after
being switched off for some time.
Allow them to cool down for a few
minutes before changing them.
Disconnect the rangehood from the
mains electrical supply before
replacing the lamps (see "Warning
and Safety instructions").
22
Remove the grease filters.
Loosen the lamp's securing screw a
little.
Slide the screw and the lamp
downwards.
Then tighten the screw again.
Turn the halogen lamp anti-clockwise
and pull it out.
Replace it with a new lamp of the
same type: GU/GZ 10, 230 V, 50W.
Refit the lamp by reversing the steps
shown above. Please observe
manufacturer's instructions.
Refit the grease filters.
Hide quick links:
Advertisement
Table of Contents
