Changing A Lamp - Miele DA 396-7 Operating And Installation Instructions

Cleaning and care

Changing a lamp

The lamps should be replaced with a
lamp of the same type:
Manufacturer ............................... EGLO
Lamp type .................................... GU10
Specification................................ 11427
Wattage ........................................... 3 W
ILCOS D Code...... DR-3-H-GU10-50/56
Alternatively the following lamps can be
used:
Manufacturer ............................... EGLO
Lamp type .................................... GU10
Specification................................ 11511
Wattage ........................................... 5 W
ILCOS D Code...... DR-5-H-GU10-50/54
These lamps have a different luminosity.
Only use lamps of the same type in the
cooker hood.
These lamps are available from Miele or
from specialist retailers.
 Switch off the fan and the lighting.

Note that lamps become very
hot when in use.
They can cause burns even after
being switched off for some time.
Allow the lamps to cool down for a
few minutes before changing them.
 Disconnect the cooker hood from the
mains electrical supply (see "Warning
and Safety instructions").
 Remove the grease filters.
24
 Turn the nut anti-clockwise as far as it
will go. The lamp will then drop down
towards you.
 Turn the lamp anti-clockwise and pull
it out.
 Screw the new lamp into the socket
and push it upwards. Please follow
the manufacturer's safety
instructions.