How To Adjust The Warm Temperature; How To Adjust The Customized Warm Function - Cuckoo CR-0631F Series Operating Instructions Manual

How to Adjust the Warm Temperature

If an odor develops, water drops are formed or the cooked rice is discolored despite frequent cleaning
and the use of sterilized water. The warm temperature may be incorrect. Adjust the temperature.
Press the "Keep Warm" button in Keep
Warm or Standby mode at length over
5 sec. The display is changed and a
buzzer sounds as shown in the above
figure. In the figure, means the
current warm temperature.
The factory setting temperature may be different from that of this manual.
To adjust the warm temperature while keeping rice warm, press the "Keep Warm" button for over 5 seconds and adjust the warm
temperature.
1. A stale smell develops and lots of water drops are formed: The warm temperature is low. Raise the temperature by 1 ~ 2 .
2. The cooked rice turns yellow, the rice gets dry and an odor develops: The warm temperature is high. Lower the temperature by 1 ~ 2 .

How to adjust the Customized Warm function

This function is used in case that water runs when you open the inner lid while keeping warm or the cooked rice is swelled up.
Press the "Keep Warm/Reheat"
button in My mode.
The display part is changed and a
buzzer sounds as shown in the
above figure. In the figure, '
means the default value.
1. If plenty of water runs out when you open the lid:
2. If the cooked rice is swollen around the edge of the rice:
'
Press the "Hrs" button to raise the setting mode by 1 or 2 stages.
Press the "Min/My mode" button to lower the setting mode by 1 or 2 stages.
Press the "Hrs" button to change
the display part in turn of
After setting the desired temperature,
press the "Cook, Keep Warm" and
"Timer" buttons to automatically enter the
value. At this time a buzzer sounds.
If you press the Cancel button or
7 seconds flow with no input, the function
is cancelled and the mode returns to
Standby mode.
Press the "Min" button to
change the display in turn of
- Press the "Hrs" button to change
the display part in turn of
After setting the desired value, press the
"Cook/Turbo" button to automatically
enter the value. At this time a buzzer
sounds.
If you press the "Cancel" button or 7
seconds pass with no input, the function
is cancelled and the mode returns to
Standby mode.
- Press the "Min/My mode" button to
change the display part in turn of