Table of Contents
Advertisement
Available languages
Available languages
OPERATION
Controls
The hood is operated using the (5) push-buttons located at eye-level, on the front
edge of the hood.
The light switch turns the halogen lights on and off. Push the light switch once to
turn the lights ON - push a second time to turn the lights ON to a brighter level -
push a third time to turn the lights OFF.
The blower on-off / speed 1 switch turns the blower on to its lowest running speed.
To turn OFF the blower, push in and hold this blower switch for approximately 2
seconds.
The blower speed 2 switch turns the blower on to medium-low running speed.
Pressing this switch a second time sets a timer which keeps the blower operating
at this speed for 10 minutes. The LED will blink during this time and the blower will
shut off automatically.
The blower speed 3 and blower speed 4 switches operate the same as blower
speed 2 switch except: Blower speed 3 is medium-high and blower speed 4 is
high.
After every 30 hours of operation, the LED above the "blower speed 1 switch" will
be illuminated (RED) and blink for 30 seconds after turning off the blower. This is
a reminder to clean the grease filters. Once the grease filters are cleaned and
installed, press in and hold the "light switch" button for approximately 2 seconds
during the blink of the LED.
HALOGEN BULBS
This range hood requires two halogen bulbs (Type JC, 12Volt, 20Watt Max, G-4
Base).
WARNING: Always switch off the electrical supply before carrying out any
operation on the appliance.
To change bulbs:
1. Open the cover by prying from the proper slots.
2. Remove the bulb by pulling sideways. (DO NOT ROTATE).
!
CAUTION: Bulb may be hot.
3. Replace with Type JC, 12Volt, 20 Watt Max, G-4 Base halogen bulb. Do not
touch replacement bulb with bare hands!
!
CAUTION: Use of bulbs greater than 20 watts will cause the fuse to
open.
FUSE REPLACEMENT
IF LIGHTS FAIL TO OPERATE, DISCONNECT POWER AT THE SERVICE EN-
TRANCE. CHECK THE FUSE AND REPLACE IF NECESSARY.
1. Raise or remove the lower decorative flue. See Figure 3.
2. Remove the cover from the electrical box.
3. Unscrew the cap from the fuse holder and remove the fuse.
4. Replace the fuse with the same size and amperage (5 x 20mm, 4 amp, 125 volt).
!
CAUTION: Use of a fuse greater than 4 amps may damage the
transformer.
5. Reinstall the fuse holder cap, electrical box cover and flue.
6. Reconnect power at the service entrance.
- 3 -
FUSE
ELECTRICAL BOX
FIG. 2
FIG. 3
Advertisement
Table of Contents
