Jøtul FS 74 Installation Instructions Manual page 41

Preparing to install the burn chamber
Fig. 11
B
1. Lift up the steel sides (A) and secure them in place using the
screws provided. Screw the fireproof board in place with 2
screws. NB: Screws must not be used if the surround is to be
installed against a combustible wall. Position and secure the
side panels (B) using the 4 bolts provided. NB: Check that it
is level.
Fig. 12-a
2. Fit the top plate (A) of the log store into place. It might be
rather a tight fit. To make installation easier, put a screw into
the plate and use this like a handle to pull the plate forward.
A
B
A
Fig. 12-b
1. Pull the top plate of the log store into place
Fig. 13
A
2. Fit the bottom plate (A) to the burn chamber.
ENGLISH
41