Whirlpool AW05CR1SRHUE Use & Care Manual page 10

Filter Monitor
1. When Filter Monitor indicator light is lit, remove, clean and
replace air filter. See "Cleaning the Air Filter".
2. Press FILTER MONITOR after cleaning and replacing the air
filter. This resets the filter monitor.
NOTE: After 360 hours of fan operating time, the filter indicator
light will turn on. It will remain on for 180 hours or until you press
FILTER MONITOR. After 180 hours, it will turn off automatically.
Temperature
Press the plus TEMP button to raise the temperature. Each
■
time you press or hold the plus TEMP button, the
temperature will go up 1°F (1°C) until it reaches 90°F (32°C).
NOTE: After 5 seconds, the display will show the current
room temperature.
Press the minus TEMP button to lower the temperature. Each
■
time you press or hold the minus TEMP button, the
temperature will go down 1°F (1°C) until it reaches 64°F
(18°C).
NOTE: After 5 seconds, the display will show the current
room temperature.
To change the temprature dislay from °F to °C:
P ress both the plus and minus TEMP buttons at the same
t ime to switch the display from °F to °C.
Timer Delay
T o set the Timer for a 30-minute to 24-hour delay until the
air conditioner turns off (the air conditioner must be On):
1. Press TIMER. Timer indicator light will flash. Display will show
remaining hours before the air conditioner will turn off.
2. Press the plus or minus TEMP button to change the delay
time from 30 minutes to 24 hours.
10
3. After 5 seconds, Timer indicator light will remain on. Display
will show the current room temperature.
T o set the Timer to turn on the air conditioner, keeping
previous settings:
1. Turn off air conditioner.
2. Press TIMER. Timer indicator light will flash. Display will show
remaining hours before the air conditioner will turn on.
3. Press the plus or minus TEMP button to change the delay
time from 30 minutes to 24 hours.
4. After 5 seconds, Timer indicator light will remain on. Display
will show the current room temperature.
T o set the Timer to turn on the air conditioner, changing
the previous settings:
1. Turn on air conditioner.
2. Adjust the mode to Cool, Dry,Fan or Power Saver.
3. For Cool mode:
Adjust fan speed to High, Med, Low or Auto.
■
Adjust temperature between 64°F and 90°F (18°C and
■
32°C).
4. For Fan mode, adjust fan speed to High, Med or Low.
NOTE: In Fan mode, temperature cannot be set.
5. For Dry mode, adjust temperature up or down by 4°F (2°C).
6. Turn off air conditioner.
7. Press TIMER. Timer indicator light will flash. Display will show
remaining hours before the air conditioner will turn on.
8. Press the plus or minus TEMP button to change the delay
time from 30 minutes to 24 hours.
9. After 5 seconds, Timer indicator light will remain on. Display
will show the current room temperature.
T o clear Timer delay program:
NOTE: Air conditioner can be either on or off.
1. Press TIMER once after it has been programmed. Display will
show remaining time.
2. While the display is showing the remaining time, press TIMER
again. Timer indicator light will turn off.
T o see or change the remaining time (in hours):
1. Press TIMER once after it has been programmed. Display will
show remaining time.
2. While the display is showing the remaining time, press the
plus or minus TEMP button to increase or decrease the time.
3. After 5 seconds, the display will show the current room
temperature.