Thermador PRD36 Installation Manual page 11

Remove all tape and packaging before using the
appliance. Please, recycle the packaging
material, as all THERMADOR
packaging material is recyclable. Never allow
children to play with packaging material.
DO NOT lift the range by the oven door's handle, as this
may damage the door hinges and cause the door to fit
incorrectly.
3. All ranges are held to the pallet by (4) bolts through a
wood block center (see Figure 5). The two front pallet
bolts are accessible only after removing the Door
Trim located beneath the doors.
• The Door Trim is removed by loosening the 2
screws attaching it to the range and sliding it up
and off the screws.
Loosen Screws
Wood Packing Blocks
Pallet Bolts
Figure 5: Door Trim, Packing Blocks, & Pallet Bolts
4. After removing the pallet bolts using (2) 1/2" (13mm)
wrenches (one to hold bolt at the bottom while the
other is loosening the nut at the top) and discarding the
wood packing block inserts, the range may be carefully
tilted back on the (2) casters and removed from the
pallet. Use additional help as required to remove from
pallet.
• PRDS48JDSGU/C models: To access the pallet bolt
located beneath the warming drawer reach up and
behind the frame of the unit with one 1/2" wrench to
hold the nut at the top (see Figure 6). Use the second
wrench to loosen the bolt at the bottom. DO NOT
remove the warming drawer.
®
appliance
CAUTION:
Figure 6: Removing Pallet Bolt Beneath Warming Drawer
• Due to the weight, a furniture dolly with soft wheels or
an air lift should be used to move this unit. The weight
must be supported uniformly across the bottom (see
Figure 7).
Range must be
uniformly
supported
by braces
provided
on bottom
of range
5. After transporting the range by dolly close to its final
location, the range can be tipped back and supported
on the rear casters while the dolly is carefully removed.
• "Step 5: Installing Anti-Tip Device", "Step 6: Gas
Requirements and Hookup", "Step 7: Electrical
Requirements, Connection & Grounding", and
"Step 8: Backguard Installation (optional)" must be
completed before the range is placed in its final
position.
6. Use the casters to assist with the installation near to its
final location. THE FLOOR UNDER THE LEGS
SHOULD BE PROTECTED BEFORE
UNIT INTO POSITION.
Figure 7: Furniture Dolly Positioning
PUSHING THE
English 9