Congratulations on your purchase of a Beltone myPAL Micro. This device complies with Part 15 of the FCC Rules and ICES-003 The myPAL Micro is a high quality portable speech and audio of the IC Rules. Operation is subject to the following two condi-...
Annex I of Council Directive 93/42/EEC for medical devices (MDD) and Essential Requirements and other relevant provisions of Directive 1999/5/EC (R&TTE). The declaration of conformity may be consulted at www.beltone-hearing.com In US: FCC CFR 47 Part 15, subpart C In Canada: IC 6941C-SM2M...
Getting Started • When charging your myPAL Micro for the first time, let it charge for at least 3 hours, even if the battery indicator indicates that Before using your myPAL Micro, you need to charge the re- the battery is fully charged.
2. With the tip of a pen blink green every 2 seconds. or similar object, press To turn the myPAL Micro OFF, press and hold the ON/ OFF but- the small pairing but- ton for approximately 1.5 seconds, until the status LED turns red ton once, as shown in –...
Pairing the myPAL Micro in channel 2 or 3 (For people using more Start streaming than one streaming device) Turn ON the myPAL Micro and make sure your hearing instru- To pair the myPAL Micro in channel 2, press the pairing button ments are turned ON.
1. Press and hold the hearing instrument program button for about 3 seconds two or three times in a row to access the 2nd Note! You may get out of range from your myPAL Micro. If or 3rd Beltone streaming device.
Wearing the myPAL Micro Clip your myPAL Micro on the speaker’s jacket or other clothing or hang it around the neck using included the lanyard. Place the device within a range of 10-40cm (4-16 inches) from the speaker’s mouth. When using the clip, make sure that the myPAL Micro is mounted vertically with the Status LED pointing towards the mouth.
Status light indicator (LED) The LED on your myPAL Micro serves as a multipurpose user interface, providing information on the status of your device. Power/Charging No charging Charging Fully charged Powered Off Powered On (Normal) Powered On (Volume control disabled)
Mute Every volume change on the on the myPAL Micro will be indicated The signal from the myPAL Micro can be muted, should the wear- by a short blink of the Mute LED. When reaching the maximum or...
Drop detection that the volume control is locked. In the event that the myPAL Micro falls from a height of more than 75 cm (30 inches), a built-in sensor will mute the output streamed How to unlock the volume control to the hearing instruments for up to 2 seconds.
Test mode • To exit Test mode and save settings turn off the myPAL Micro and lock the volume control (see Volume control lock section The Test mode is primarily intended to be used for pediatric trans- in the Special features chapter).
• myPAL Micro may only be repaired by an authorized service where there is a danger of ignition of flammable gasses. center. • Do not use myPAL Micro in areas where RF transmission is General precautions prohi-bited, e.g. air planes etc.
• If left unused, a fully charged battery will lose its charge over • Only recharge the myPAL Micro with a power supply unit that time. has been supplied together with the product.
• Use of other chargers may invalidate any approval or war- ranty. Do not charge the myPAL Micro while it is on your body. • For availability of approved enhancements, please check with your hearing care professional. • Charge the product according to the instructions supplied with the product.
Your Hearing Care Professional may have The myPAL Micro is covered by a limited warranty issued by the issued a warranty that goes beyond the clauses of this limited manufacturer for a period of 12 months from the day of the origi- warranty.
Unlock the volume control (see Volume control lock chapter) volume control specific level The myPAL Micro and the hearing Assure that myPAL Micro and the hearing instruments are within instrument are out of wireless range wireless range There is no sound in the...
Page 21
The myPAL Micro and the hearing Assure that the myPAL Micro and hearing instruments are within instrument are not within wireless wireless range and repeat pairing process range...
Page 22
TROUBLESHOOTING GUIDE Symptom Possible Cause Possible Remedy Clip the myPAL Micro on the speaker’s jacket or other clothing or The myPAL Micro is not worn cor- hang it around the speaker’s neck using the lanyard, placing the rectly by the speaker The sound level from the device within 10-40 cm (4-16 inches) from the speaker’s mouth...
Page 23
CAUTION indicates a situation that could lead to minor concerning disposal of your myPAL Micro and moderate injuries. Advice and tips on how to handle your Beltone acces- sory better. Any issues relating to the EU Medical Device Directive 93/42/...