Table of Contents
Advertisement
1. Plastic clip (2)
4. Secure the bottom of the fuel tank to the fuel tank
bracket by installing the self-tapping screws from the
bottom. Torque the screws to 40 to 50 in-lb (4.5
to 5.6 N-m). Do not overtighten the screws.
4
Installing the Discharge Tunnel
Plug
Parts needed for this procedure:
1
Discharge tunnel plug
Procedure
1. Open the discharge door by pulling forward on the
handle and moving it rearward (Figure 7). Hold the
discharge door handle to prevent the spring-loaded
door from closing while you insert the plug.
Figure 6
1. Discharge door handle
2. Since the plug is slightly wider than the discharge
tunnel opening, rotate the plug clockwise slightly
while inserting it (Figure 7).
Note: Ensure that the arrow on the plug decal
points upward.
3. Push the plug all the way in until the spring clip on
the bottom of the plug clicks into place, locking the
plug securely into the discharge tunnel (Figure 8).
1. Spring clip
4. Release the discharge door handle to lock the top
of the plug.
10
Figure 7
2. Plug, rotated clockwise
Figure 8
Advertisement
Table of Contents
