Installing The Starter Rope; Installing The Discharge Tunnel Plug - Toro 20789 Operator's Manual

3. Secure the handle to the support brackets with the two
flat handle bolts and two knobs, using the height
adjustment holes on the brackets that best fit your
height (Fig. 2)
IMPORTANT:
Keep the cables from pinching or
stretching.
Note: You can adjust the handle height by installing the
handle bolt and knob through a different set of holes.
4. Slide the upper handle section ends over the lower
handle so that the sections nest together (Fig. 3)
5
2
Figure 3
1. Cables
2. Lower handle
3. Upper handle
5. Make sure that the cables are routed below and behind
the lower handle as illustrated in Figure 3.
6. Secure the upper handle to the lower handle using two
contoured handle bolts and two knobs (Fig. 3).

Installing the Starter Rope

Pull the starter rope through the rope guide on the handle
(Fig. 4).
4
3
1
m–4204
4. Contoured handle bolt
(only one shown)
5. Knobs
1. Rope guide
Note: To make the starter rope easier to install, squeeze
the control bar on the handle.
Installing the Discharge Tunnel
Plug
1. Stop the engine and wait for all moving parts to stop.
2. Open the discharge door by moving the handle
rearward (Fig. 5).
1. Discharge door handle
3. Hold the discharge door handle to prevent the
spring-loaded door from closing while you insert the
plug.
4. Rotate the plug clockwise slightly while inserting it
(Fig. 5).
Make sure that the arrow on the plug decal points
upward.
5. Push the plug all the way in until the spring clip on the
bottom of the plug clicks into place (Fig. 6).
8
210
Figure 4
2. Starter rope
1914
Figure 5
2. Plug (rotated clockwise)