BT 1010 User Manual page 9

3. On the hub:
Put the hub into registration mode, by pressing the
wireless association key (located on the back of
the hub).
The Power / in use LED flashes.
It is now ready to be associated with a new handset.
This registration mode lasts 90 seconds after pressing
the button. Once this is completed the LED is
switched off.
Getting started
see page 46. If the battery runs out
you will be cut off. You will need to
recharge the handset before using
it again.
During charging, the
scroll in the display.
Battery performance
To keep your batteries in the best
condition, leave the handset off the
base for a few hours at a time.
Running the batteries right down at
least once a week will help them
last as long as possible.
The charge capacity of
rechargeable batteries will reduce
with time as they wear out, giving
the handset less talk/standby time.
Eventually they will need to be
replaced. New batteries are
available from the BT Hub Phone
1010 Helpline on 0845 600 7030. 0800 111 4567.
9
icon will