Cleaning The Milk System - Bosch TES 502 Operating Instructions Manual

en

Cleaning the milk system

If the milk system was not cleaned after
milk has been dispensed, after a certain
amount of time the message
system!
will appear on the display.
Clean the milk system immediately after use!
To pre-clean the milk system automatically:
f
1. Select by turning the rotary knob (14).
2. Place a receptacle under the milk
frother (6).
3. Press the start button (10).
4. Pull the milk frother (6) to open it. The
appliance now automatically fi lls the
receptacle with water. The rinse pro-
cedure stops automatically after about
1 minute.
5. Push the milk frother (6) in to close it.
6. Let the milk frother (6) cool down.
7. Empty the receptacle and wipe dry the
outside of the milk frother (6).
In addition to this, clean the milk system
thoroughly at regular intervals (by hand or
in the dishwasher).
Dismantling the milk system for cleaning:
1. To remove, take hold of the metal sleeve
and pull it downwards and off.
2. Twist the steam nozzle (6d) anticlock-
Rinse milk
3. Remove the frothing tube (6c).
4. Clean the individual parts with a
5. Rinse all parts with clean water and dry.
6. Fit the steam nozzle (6d) and frothing
7. Twist the steam nozzle clockwise until
wise and remove it.
6c
detergent solution and a soft brush. If
necessary, soak in a warm detergent
solution. Clean the air hole (6e)
thoroughly.
tube (6c) back into the metal sleeve.
6c
1
the marks are aligned.
11 11
1
6d
2
6e
6d
2
TES502 | 02/2013