Shark S2901SL Owner's Manual page 15

fig. 20
USING THE WEDGE CLEANING TOOL
Cleaning Tip: The Wedge Cleaning Tool
was designed for cleaning a variety of
surfaces and is exceptional on those that are
large and flat, both horizontal and vertical.
Broad cleaning sides and super absorbent
microfiber fabrics loosen, lift, and lock in dirt
and grime while sanitising at the same time.
The wedge tip and squared edges reach
into tight areas often missed or difficult to
reach with traditional cleaning methods. The
Wedge sides concave to wrap around sink
and faucet fixtures, door knobs, and other
small curved surfaces leaving them clean all
around. Multiple sides provide more surface
cleaning area and allow one to clean with
one side and finish with the other. Surface
examples for use are countertops, tabletops,
cabinets, walls, floor spot cleaning,
bathroom fixtures and more.
1
Slide the Wedge All-Purpose Pocket over the
Wedge Cleaning Tool frame until it is completely
on. (fig. 20)
2
Close the cinch by pulling on the elastic band and
sliding the locking bean to tighten. (fig. 21)
3
Attach the Wedge Cleaning Tool by snapping into
the handle of the Accessory Hose until it clicks
into place. (fig. 22)
4
Press the power button to start steaming.
5
To remove the Wedge Cleaning Tool, press and
hold down the Accessory release button. Then
slide out the Wedge Cleaning Tool.
CAUTION: Turn the unit off before attaching or
removing the Wedge Cleaning Tool. Always use
the Wedge Cleaning Tool with a pocket attached.
CAUTION: It is recommended that you allow the
cleaning pockets to cool off before removing them
from the Wedge Cleaning Tool to avoid possible
scalding injury.
fig. 21
fig. 22
11