Shark S2901SL Owner's Manual page 12

Using Your Removable Handheld Steamer
with the Different Accessories - cont.
USING THE CONCENTRATOR NOZZLE
Cleaning Tip: The Concentrator Nozzle
creates direct steam spray to clean and
sanitise hard to reach nooks & crannies and
other places where germs may build up.
Use the Concentrator Nozzle to loosen and
dislodge compact dirt often found in corner
and tight places where traditional methods
and cleaning tools tend to push dirt into,
making it tough to reach and clean. Spray
direct steam and wipe clean with a wet cloth
or paper towel.
1 Attach the Concentrator Nozzle by pressing the
nozzle onto the Accessory Hose until it clicks into
place. (fig. 13)
2
Press the power button to start the steamer.
For effective cleaning, hold the steam output
nozzle 1-2 inches away from the surface you're
cleaning.
CAUTION: Do not press the power button
until the Concentrator Nozzle is snapped into the
accessory hose of your Handheld Steamer.
3
To remove the Concentrator Nozzle, press and
hold the accessory release button, then pull it out
of the Accessory Hose.
CAUTION: Do not press the power button while
removing the Concentrator Nozzle. Avoid touching
the tip of the Concentrator Nozzle, as this will be
very hot after steaming.
NOTE: The Handheld Steamer may continue
to emit steam for a few seconds after the power
button is pressed to turn the unit off. This is
normal, and the steaming will eventually come to
a stop.
8
fig. 13
USING THE GROUT SCRUBBER OR
DETAIL BRUSH
Cleaning Tip: The Detail Brush and the
Grout Scrubber are designed for removing
stubborn messes in hard-to-reach nooks,
corners and in grout where focused
scrubbing power may be needed. They can
loosen and dislodge compact dirt often
found in corners and tight places where
traditional methods and cleaning tools tend
to push dirt into, making it difficult to reach
and clean. Scrub with the Grout Scrubber or
Detail Brush and wipe clean with a cleaning
cloth.
1 Attach the Grout Scrubber or Detail Brush by
snapping into the handle of the Accessory Hose
until it clicks into place. (fig. 14)
2
Press the power button to start steaming.
3 To remove the Grout Scrubber or Detail Brush,
press and hold down the Accessory release
button. Then slide out the tool out.
CAUTION: Turn the unit off before attaching or
removing the Grout Scrubber or Detail Brush.
fig. 14