Network Configuration; Connecting Your Radio To Your Computer Network - Sangean DDR-66BT Instruction Manual

Configuration

Connecting your radio to your computer network

1. Place your radio on a flat surface and plug the mains lead into the mains socket located on the
back of your radio ensuring that the plug is pushed fully into the socket.
2. If you wish to use a wired network connection, plug the Ethernet cable into the socket at the
back of the radio.
3. Plug the other end of the mains lead into the wall socket and switch on the wall socket.
IMPORTANT:
The mains plug is used as the means of connecting the radio to the mains supply. The mains
socket used for the radio must remain accessible during normal use. In order to disconnect
the radio from the mains completely, the mains plug should be removed from the mains socket
outlet completely.
4. When you apply power, the display on the radio will light up and say: 'SANGEAN'
and'STARTING' with a progress indicator. The first time that you use your radio (or after
Factory Reset) the display will show "Setup wizard" and "YES" will be highlighted on the
screen. Press the Select button to start the setup wizard. The screen will ask if you wish to run
the setup wizard again at the next start up. This will lead to the main menu.
5. Press the Tuning Up or Down buttons on the touch panel (Alternatively, the Folder Up or Down
buttons on the remote control handset) to highlight the desired clock format (either 12 Or 24
hour) then press the Select button to enter your selection. A menu allowing you to specify
the auto update option for the clock will appear on the display. The default of 'Update from
Network' will be the best option for most users.
WELCOME TO
DIGITAL RADIO
Setup wizard
Start now?
Date/Time
12/24 hour format
GB
12