Adjusting The Dryer; Electrical Requirements - Haier HLTD500AGW Service Manual

SERVICE MANUL
Model No.HLTD500AGW
No. of 90
elbows
0
1
2
3

7-3. Adjusting the Dryer

There are adjustable feet under the bottom of the
dryer. Before use, the dryer should be adjusted,
as shown in the right figure, so that it is level.

7-4. Electrical Requirements

Circuit
Individual 15 Amp branch circuit fused with 15-Amp maximum time delay fuse
or circuit breakers.
Power Supply
3 or 4 wire, 120/240 Volt, 1 Phase, 60Hz, AC
Power Supply Cord
The dryer is equipped with a 120 Volt 3-wire power supply cord.
Note:This dryer is equipped with a three-prong grounding plug for your protection against
shock hazard and should be plugged into a properly grounded three-prong receptacle.
Do not under any circumstance cut or remove grounding prong from plug.
RECOMMENDED MAXIMUM
Recommended
o
Rigid
Flexible Metal
Metal
9 0 . t f Flexible metal
metal shoud only
6 0 . t f
length to be 7.5ft.
4 5 . t f wall. Maximum
the dryer and the
35 ft.
be used between
Exhaust Hood Types
Use only for short
run installations
Rigid
Metal
6 0 . t f
metal shoud only
4 5 . t f
length to be 7.5ft.
3 5 . t f
the dryer and the
25 ft.
be used between
- 16 -
Issue
Rev.
Flexible
Metal
Flexible metal
wall. Maximum