Haier HLTD500AGW Service Manual page 21

SERVICE MANUL
Model No.HLTD500AGW
Parts List
4 Hold Down Bracket
8 " Wood Screw
#10 X 1/2
1 Installation Instructions
Installation Instructions
1. Place dryer in location where it is to be
installed. Refer to the User Manual for
information about locating your dryer.
NOTE: Allow adequate space between
the back of dryer and the wall to ensure
proper exhaust connection.
2. Level the dryer by adjusting the leveling
feet. Check with a carpenters level.
3. Assemble the exhaust duct to the dryer.
NOTE: The exhaust duct MUST NOT
terminate under the manufactured home.
The exhaust duct MUST be secured to
the structure. Refer to the User Manual
for complete exhaust requirements.
4. Measure the distance from the back of
the dryer to the wall as shown in Figure 1.
Measure and mark the centerline of the
dryer as well. Note that the exhaust duct
connection to the dryer is located on the
dryer centerline.
5. Disconnect the exhaust duct and move
the dryer away from the wall, allowing
adequate room to work behind the dryer.
Installation Instructions, Cont'd
6. Using the measurements from Step 4, install (2) Hold Down Brackets as shown
in Figure 2 using (4) #10 X 1/2" Wood Screw. Note the correct bracket orientation.
7. Move dryer back into place so that the rear leveling feet engage the hold down brackets.
8. Install the exhaust duct.
9. With the dryer in place, install the two remaining hold down brackets to engage the front
leveling feet.



Figure 1
- 20 -
Issue
Rev.