Electrical Connection; Safety Devices - Omcan 28 Instruction Manual

ELECTRICAL CONNECTION:

The appliance is available in with a choice of two voltages for the power supply.
• 100V 50 Hz - 120V 60 Hz single phase.
• Line protection: the appliance should be connected to a standard 2-pole + grounding electric socket. The
installation should be fitted with an RCD and a fuse rated at 16A. The appliance must be grounded.
WARNING
• Before connecting the machine, check that the mains electrical voltage is the same as the voltage for your
appliance. Its value is shown either on the identification plate under the machine or on the identification
plate on the last page of this manual.
• If the power cable (10) is damaged, it should be replaced by a trained technician.

SAFETY DEVICES

COVER AND BOWL PRESENCE SAFETY DEVICE:
For the juice extractor to be able to start, the cover (2) and the bowl (4) must be centered in position on the
bowl centering device (7) and held by the clamping handle (1). Putting the clamping handle in the vertical
position (up) without the bowl or without the cover means that the machine cannot be started.
MOTOR OVERLOAD SAFETY FEATURE:
Models 110-120V 50/60Hz.
Should the motor become blocked (foreign objects, objects that is too hard, too much pressure with the fruit
plunger on the products being processed), the motor overheating safety feature triggers and switches off the
motor (see overheating safety feature).
MOTOR OVERHEATING SAFETY FEATURE:
Models 110-120V 50/60Hz only.
In the event of the motor overheating, the appliance stops automatically. The safety feature has an automatic
reset, so wait for the motor to cool (15 to 30 minutes), before restarting the machine. If the problem persists,
switch off the power supply to the machine (unplug the cord from the mains socket (10)) and call the Omcan
Service Center at 1-800-465-0234.
SAFE ACCESS TO THE TOOLS:
The juice extractor can only be started if the cover and bowl are positioned correctly on the bowl centering
device (7) and the clamping handle (1) is locked. Releasing the clamping handle (1) results in the machine
stopping and stops the rotating elements in less than 3 seconds. Re-starting the juice extractor requires
specific operation of the On switch (11) again. A cut in the mains power supply makes the machine stop.
Safety and Warranty
1 YEAR WARRANTY
5