filter will appear on the display.
Refer to Chapter 5.2 «Replacing the filter».
16.6 Cleaning the coffee machine
After 200 draw‐off operations or after 160 rinsing
operations, the coffee machine must be cleaned. A
message appears on the display, telling you to start the
cleaning programme. You can still draw off coffee or hot
water/steam. However, we recommend that you should
clean the machine (Chapter 17) within the next few
days.
DISPLAY: READY
CLEAN
16.7 Coffee machine decalcify
During operation, the machine will calcify. The degree
of scaling depends on the hardness of the water in your
region. The machine will inform you when de‐scaling is
required. You can still draw off coffee or hot
water/steam. However, we recommend that you should
de‐scale the machine (Chapter 18) within the next few
days.
DISPLAY: READY
CALCIFIED
16.8 General cleaning instructions
⑴ Never use scratching objects, pan cleaners, cleaning
sponges or caustic chemicals to clean the machine.
⑵ Wipe off the case on the inside and outside using a soft,
moist cloth.
⑶ Clean the replaceable hot water nozzle after each use.
⑷ After heating milk, draw off some hot water, to clean
the inside of the replaceable 2‐stage frothing jet, too.
⑸ Disassemble the 2‐stage frothing jet for proper cleaning
(Fig. 6).
⑹ The water tank should be rinsed daily and refilled with
fresh water.
⑺ If the water tank shows signs of scaling, remove the
scaling using a commercial de‐scaling solvent. Take out
the water tank (Fig. 4).
⑻ Remove the Claris filter cartridge, if installed, before
descaling the water tank.
16.9 Emptying the system
Precondition: coffee machine switched off
This operation is required to protect the COFFEE
MACHINE against frost damage during transports.
⑴ Place a container under the replaceable hot water
nozzle (16).
⑵ Press the steam pre‐selection key (8) until the
following message is displayed:
DISPLAY: OPEN TAP
EMPTYING
17
Need help?
Do you have a question about the wsd18-060 and is the answer not in the manual?
Questions and answers