Peavey PV 1015 D Operating Manual page 25

® ®
PEAVEY PV 1015D - SPECIFICATIONS
Frequency Range: 1 meter on-axis, swept-sine in 1/2 Space
environment, -10 dB: 43 Hz to 21 kHz
Frequency Response: 1 meter on-axis, swept-sine in 1/2 Space
environment 63 Hz to 18 kHz (± 3 dB)
Sensitivity (1w/1m): 95 dB
Maximum Peak SPL: 121 dB
Transducer Compliment: Heavy-duty 15" Pro 15 woofer with 2 3/8"
™
voice coil & 50 oz. Magnet. RX
compression driver, loaded on a Peavey exclusive 100 degree by 50
degree Quadratic Throat Waveguide
Nominal Coverage Pattern: 100° horizontal X 50° vertical. Axis of the
vertical main polar lobe is angled down 10°, resulting in the angular
pattern with respect to straight ahead being +15, -35°
Electro-Acoustic Crossover Frequency: 2.8 kHz
Input Connections: One combo female XLR/ 1/4" phone jack
providing balanced or unbalanced operation.
Enclosure Materials & Finish: Trapezoidal, black carpet covered
15mm MDF, black powder-coated full length perforated steel grille.
Mounting or Suspension: Steel 1 3/8" pole-mount cup for stand
mounting, four rubber feet for floor use.
NOTE: This unit is not designed for overhead suspension!
Dimensions (H x W x D):
Front: 27.56in. X 18.13 in. x 16.88 in.
700 mm x 461 mm x 429 mm
Rear: 27.56in. x 15.38 in. x 16.88 in.
700 mm x 391 mm x 429 mm
Weight:
56 Lbs. (25.4 kg)
14 1.4" titanium diaphragm dynamic
™
.
ELECTRONICS AND AMPLIFIER SPECIFICATIONS:
Power Amp Rating, Total Power Output:
800 watts peak available power. Continuous power 400 watts into 4
ohms @ less than 1% distortion
Electronic Input Impedance (Nominal): 2.7 k ohms balanced (XLR or
1/4"), 1.35 k ohms unbalanced 1/4".
Infrasonic Filter Protection: 24 dB/octave roll-off
Nominal Amplifier Frequency Response: +0, -3 dB from 20 Hz to 20 kHz
Hum and Noise: Greater than 90 dB below rated power
DDT Dynamic Range: Greater than 14 dB
THD and IM: Typically less than 0.5 %
Damping Factor: Greater than 400 @ 1000 Hz, 8 Ohms
Power Requirements of Peavey PV
Watts, Voltage and Frequency Ranges: 100-120 VAC, and 220 –
240VAC, at 50- 60 Hz
Fuse Type:
For 100-120 VAC USE: International fuse classification T6.3AL . In
the USA, types GDC, GMC, 215, 218, and 477 cartridge-style 5 x 20
mm size fuses with a 6.3 amp 250V rating can be used.
For 220-240VAC USE: International fuse classification T3.15AL . This
is a cartridge style 5 x 20 mm size time-delay fuse with a 3.15 amp
250V rating.
® 2015D System: Nominal 370