Peavey PR 12 D Operating Manual
Powered bi-amplified two-way speaker system
Hide thumbs
Also See for PR 12 D:
- Operating manual (17 pages) ,
- Specifications (4 pages) ,
- Operating manual (25 pages)
Related Manuals for Peavey PR 12 D
Summary of Contents for Peavey PR 12 D
- Page 1 12 D ® Powered bi-amplified two-way speaker system Operating Manual www.peavey.com...
- Page 4 ENGLISH Features Description...
-
Page 5: On/Off Switch
Applications R E A R P A N E L FUSE IEC POWER CORD CONNECTION ON-OFF SWITCH... - Page 6 F R O N T P A N E L GROUND LIFT GROUND LIFT PRIMARY INPUT (CHANNEL 1) PAD STATUS LED VOLUME POWER/CLIP LED POWER/CLIP LED LINK OUT LINK OUT DIRECT IN DIRECT IN...
- Page 7 O P E R A T I N G I N S T R U C T I O N S Flying the PR ® Caution: The suspending or flying of the Peavey must be done by a certified structural engineer.
- Page 8 Connecting AC Power To The PR ® Special Note for Permanent Installation Use of PR 12D with a Subwoofer Connecting a Signal to the PR 12D Volume Control Adjustment...
-
Page 9: Troubleshooting
Mic/Line Pad Adjustment Mic/Line Pad A TROUBLESHOOTING No Output at All Hum or Buzz Distorted or Fuzzy Sound... - Page 10 Care and Maintenance Sunlight/Heat Cleaning Touchup Check for Secure Hardware Architectural and Engineering Specifications...
- Page 12 Nominal Radiation Angles: Nominal Amplifier Frequency Response: Transducer Complement: Dimensions: Hum and Noise: DDT Dynamic Range: Box Tuning Frequency (Fbox): Optional Accessories: THD and IM: Electroacoustic Crossover Frequency: Damping Factor: Crossover Type: Net Weight: Power requirements of Peavey ™ 12P System (domestic):...
-
Page 13: Frequency Response Curves
FREQUENCY RESPONSE CURVES Amplitude Response (1m On-Axis) Frequency (Hz) Figure 1... - Page 14 Logo referenced in Directive 2002/96/EC Annex IV (OJ(L)37/38,13.02.03 and defined in EN 50419: 2005 The bar is the symbol for marking of new waste and is applied only to equipment manufactured after 13 August 2005...
- Page 15 U.S. customer warranty registration. Logo referenced in Directive 2002/96/EC Annex IV (OJ(L)37/38,13.02.03 and defined in EN 50419: 2005 The bar is the symbol for marking of new waste and is applied only to equipment manufactured after 13 August 2005...