SCAN DSA 8 Instructions For Installation And Use

Download this manual

I N S T R U C T I O N S

I N S T A L L A T I O N

DSA 8 & DSA 8-5

Congratulations on your new SCAN insert!

You have chosen a product from one of Europe's leading manufacturers of wood-burning stoves. We are convinced that your

insert will be to your full satisfaction and give you many hours of pleasure if you follow the advice and instructions of this manual.

Please read this manual as well as the General Instructions for Installation before beginning the installation.

SCAN

EN 13229 2005

This manual is accompanied by a

pamphlet with General Instructions for

Installation.

F O R

A N D

U S E

Edition GB 26.03.07

Need help?

Do you have a question about the DSA 8 and is the answer not in the manual?

Page 1 A N D U S E SCAN DSA 8 & DSA 8-5 Congratulations on your new SCAN insert! You have chosen a product from one of Europe's leading manufacturers of wood-burning stoves. We are convinced that your insert will be to your full satisfaction and give you many hours of pleasure if you follow the advice and instructions of this manual.
Page 2 - Remove the damper in the existing fireplace/chimney. Clean the fireplace thoroughly of any soot residues. When connecting the SCAN DSA 8 or 8-5 you can use flexible tubes as well as steel tubes. If you use flexible tubes, this may reduce the draught in the stove considerably; we therefore recommend the use of steel tubes.
Page 3: Primary Air
SCAN DSA 8 & 8-5 ing the glass clean. If you close the Secondary air too CB-technique (Clean-Burn) much, the risk of getting sooty glass is increased. You can Wood-burning inserts equipped with a Clean-Burn technique regulate the desired heat quantity with the Secondary air.
Page 4 SCAN DSA 8 & 8-5 in an existing fireplace If you plan to insert a SCAN DSA 8 or 8-5 into an existing open fireplace, it is important that you keep a distance of 3-5 mm around the masonry. This will prevent cracks in the bricks, as metal expands when heated.

Dsa8-5