Table of Contents
Advertisement
OPERATING INSTRUCTIONS
WARNING
Always perform
SPECTION
before operating the
boat. Become thoroughly familiar
with all controls and the function
of each. Should any control or in-
struction be not fully understood,
refer to an authorized Sea-Doo
Sport Boats dealer.
Operating During Break-in
NOTICE
Carefully follow the in-
structions in this section. Failure to
do so may reduce the life and/or per-
formance of the engines.
With Sea-Doo Sport Boats powered
by Rotax
®
engines, a break-in period
of 10 hours is required for each en-
gine before continuous operation at
full throttle.
To achieve a good break-in, throttle
levers should not be advanced more
than 3/4 opening, however, brief accel-
eration and speed variations contribute
to a good break-in.
NOTICE
Continued
throttle runs and prolonged cruis-
ing without speed variations should
be avoided. This can cause engine
damage during the break-in period.
Launching/Loading
NOTICE
Before
boat, ensure the main battery cut-off
switch is turned ON and the bilge
plugs are fully screwed into place.
When finished loading the boat on trail-
er, turn the main battery cut-off switch
to OFF.
Remove bilge plugs to drain bilge when
boat is on trailer.
PRE-RIDE IN-
wide
open
launching
the
_______________
Boarding from a Dock
As with any boat, boarding should be
done carefully and engines must not
be running.
When boarding from a dock, slowly
place one foot on the boat deck near-
est to the dock and then move the oth-
er foot inside the boat. Push the boat
away from the dock.
F04L06Y
TYPICAL
NOTICE
Although the boat re-
quires only 30 cm (1 ft) of water to
float, the engines should be start-
ed with at least 90 cm (3 ft) of water
below the hull. If the depth of the
water is less than 90 cm (3 ft) and
the engine is running, the impeller
is turning and debris can be drawn
from the bottom and damage the
propulsion system.
F04L07Y
TYPICAL
A. 90 cm (3 ft)
A
A
69
Advertisement
Table of Contents
